Sentry NC-GSMDE263 Manual do Utilizador descarregar pdf (Página 15)

Contacting a Subscriber

At the "Welcome!" screen, enter User ID number (from 1 ~ 999999) and then press the CALL button.

If the ID exists, the system will start dialing and show “Calling…” on the screen. When the phone is

connected, the screen will show “Talking”.

If the ID does not exist, the screen will show “Incorrect!”.

If the ID exists, but there is no number assigned, the screen will show “Calling…”, but will never

connect and time out after 3 minutes. In order to avoid this problem, please make sure to input the

phone number on each User ID.

If the dialing attempt fails, the screen will show “No dial tone” and go back to “Welcome!”.

If the call is not answered within a 1 minute, the screen will show “No Answer” and go back to

“Welcome!”.

During a conversation, if the other party hangs up or the line is cut, the screen will show “No

Carrier” and go back to “Welcome!”.

During a conversation or while dialing, pressing MENU or C button will stop the

conversation.

Open the Door Remotely

During a conversation, the called party can press the ＊ button to open the door. The door-open

time can be set by user. The default setting is 3 seconds.

Calling- - -

Incorrect!

No dial tone! Welcome!

No answer! Welcome!

No carrier! Welcome!

Talking- - -

Calling- - - Time’s Up!

1 2 ... 10 11 12 13 14 15 16

Sem comentários

Sentry NC-GSMDE263 Manual do Utilizador Página 15